7/9/2023 0 Comments Inventor 2020 camPost Processor: A new variable 'machineParameter.spindleSpeedDwell' has been added which specifies a dwell time in seconds when the spindle speed changes during a drilling cycle.There are also corresponding 'axis.getReset' and 'tReset' functions. ![]() Fixed an issue which could have caused gouges when smoothing for sampling strategies is enabled.Fixed an issue where some arcs were misformed when offset.Fixed an issue which caused irregular cutting passes for the scallop strategy.Fixed an issue in which entry positions were inadvertently removed from 2D Chamfer operations.Contour with Both Way and Roughing Passes used to produce partial toolpaths.Jet will now provide the user with a better warning when no path can be computed.Fixed an issue in which helical links were detached from their cutting segment and a further lift and plunge was inserted in between to join them.Fixed an issue where faceting could occur in Scallop operations.Fixed an issue in which toolpaths might not get created when using the "Fillet" option (Mac only).Fixed an issue where the software could hang when calculating helical ramps on a contour pass.Allow machining two open bores within the same operation.When using a cutter with a corner radius in 2D Adaptive, the upper edge of a pocket could be gouged in some circumstances this is corrected.Avoid incorrect parenting of the Machine Select dialog, which could lead to a crash.Fixed several issues in which toolpaths were not being invalidated when specific parameters were changed: Safe Z, Origin or Chuck Front in a turning setup, Entry and Pre-drill positions, Bottom Height 'from selected point'.Fixed an issue in which the stock contours preview was incorrect when another tool orientation was selected in the operation.This can be used to correct expanded gun-drilling cycles.
0 Comments
Leave a Reply. |